5 combined av headset application, 1 building the combined headset application, Combined av headset application – CSR BlueLab v3.2 User Manual
Page 8: Building the combined headset application, Figure 5.1: bluecore3-multimedia development board, Äìéi~ä, Îpko= combined a v headset u ser guide, 5combined av headset application
Combined AV Headset Application
blab-ug-005Pa
© Cambridge Silicon Radio Limited 2005
This material is subject to CSR’s non-disclosure agreement.
Page 8 of 24
_äìÉi~Ä
»
=îPKO=
Combined A
V Headset U
ser Guide
=
5
Combined AV Headset Application
When BlueLab v3.2 has been successfully installed, the Combined AV Headset application can be built and
executed using the application source code, shipped with BlueLab v3.2.
This section guides you step-by-step through the process of building and executing this application.
The application implements the following profiles:
!
Headset Profile
!
Handsfree Profile
!
Advanced Audio Distribution Profile
!
Audio/Video Remote Control Profile
This enables stereo music to be streamed to the headset with the ability to accept and make telephone calls via a
Bluetooth-enabled mobile phone.
5.1
Building the Combined Headset Application
Step 1: Connect BlueCore3-Multimedia Development Board
1. Connect your BlueCore3-Multimedia Development Board to your PC per the instructions supplied with
the development kit.
2. Ensure that you have connected the mini-USB connection and the SPI connection.
3. Turn on the board and ensure that the jumpers are configured as shown in Figure 5.1.
Figure 5.1: BlueCore3-Multimedia Development Board
ON
ON
ON
OFF