Satellite Dispenser 4 Roll - Manual (Page 2)

19407 Rev.A, - 2 - 4/07
TUFWAY
Fasten the 4 roll paperguard to panel using #11027 (3) Rivet, #66 alum and #11315 (3) Washer, 3/16 stnls.
Fasten paperguard on the inside with washer and rivet from the outside of the toilet. Using the top hole on
the inside of paperguard and Transfer drill bottom two holes (one on each side) through paperguard and
fasten to panel.
Maxim 2000
1. Mounting location
without slimmate. Mark
inside right panel near
front. 3-1/4” up from
bottom of logo area and 4-
1/4” over from left edge of
logo area. Then drill hole
using #10 drill bit
2. Mounting location with
slimmate. Mark inside left
panel near rear. 14” up from
bottom of logo area and 17-
3/8” over from left edge of
logo area. Then drill hole
using #10 drill bit 3. Location without
slimmate 4. Location with slimmate
Fasten the 4 roll paperguard to panel using #11027 (1) Rivet, #66 alum and #11315 (3) Washer, 3/16 stnls.
Fasten papergaurd on the inside with washer and rivet from the outside of the toilet. Using the top hole on
the inside of paperguard and Transfer drill bottom two holes (one on each side) through paperguard and
fasten to panel using #11024 (2) Rivet, #610 AAP on bottom two holes.
1. Mounting location
without slimmate. Mark
inside right panel near
front. 3-3/4” down from
bottom of logo area and 6-
5/8” over from molded
feature in center panel.
Then drill hole using #10
drill bit 2. Mounting location with
slimmate. Mark inside rear
panel. 3-3/4” down from
bottom of logo area and 6-
5/8” over from left edge of
molded feature in panel. Then
drill hole using #10 drill bit 3. Location without
slimmate 4. Location with slimmate