Satellite Dispenser 4 Roll - Manual (Page 3)

19407 Rev.A, - 3 - 4/07
DOUBLE WALL UNITS
High Tech (Caution: Do not drill through outside wall of panel)
1. Mounting location without
slimmate. Mark inside right
panel near front. 11-1/4” down
from bottom of screen area
and 3-5/8” over from molded
feature in panel. Then drill hole
using #10 drill bit
2 . Mounting location with
slimmate. Mark inside right panel
near middle. 11-1/4” down from
bottom of screen area and 3-5/8”
over from molded feature in panel
Then drill hole using #10 drill bit.
3. Location without
slimmate 4. Location with slimmate
Fasten the 4 roll paperguard to panel using #17030 (3) Rivet, avdel black. Fasten paperguard on the inside of the toilet.
Using the top hole on the inside of paperguard and Transfer drill bottom two holes (one on each side) through
paperguard and fasten to panel. Note: Be careful just to drill through first layer only.
High Tech II
1. Drill out (3) dimples located on
inside, right front corner of unit
[about 1/2 the way up from the base
on right door frame right side panel]
using a # 10 Drill bit "be careful not
to drill through outside wall of
front / panel". 2. Secure 4 roll toilet paper holder
P/N 18955 to front / panel using
rivet Avdel silver P/N 17436 (1)
on inside at top of dispenser
[toilet paper holder lid needs to
be open]. 3. Secure 4 roll toilet paper holder
P/N 18955 to front / panel using
rivet Avdel silver P/N 17436 (2
total, one per side) on outside
near bottom of dispenser.
Fasten the 4 roll paperguard to panel using #17030 (3) Rivet, avdel black. Fasten papergaurd on the inside of the toilet.
Using the top hole on the inside of paperguard and Transfer drill bottom two holes (one on each side) through
paperguard and fasten to panel. Note: Be careful just to drill through first layer only.
Maxim 3000
1. Mounting location
without slimmate. Mark
inside right panel near
front. 15” up from top two
dimples for mounting
paperguard and 5” over
from molded feature in
center panel. Then drill
hole using #10 drill bit
2. Mounting location with
slimmate. Mark inside left
panel near rear. 15” up from
top two dimples for mounting
paperguard and 21-1/2” over
from molded feature near
front of panel. Then drill hole
using #10 drill bit 3. Location without
slimmate 4. Location with slimmate
Fasten the 4 roll paperguard to panel using #17030 (3) Rivet, avdel black. Fasten papergaurd on the inside of the toilet.
Using the top hole on the inside of paperguard and Transfer drill bottom two holes (one on each side) through
paperguard and fasten to panel. Note: Be careful just to drill through first layer only.