Woo Audio WES - Manual (Page 10)

©2011 WOO AUDIO tm Inc. All rights reserved. www.wooaudio.com Rev 1.0. June 10, 2011. 10
Installing the source input:
Plug the RCA interconnection cable into the RCA connectors; see ③ in the above diagram. Or,
plug the XLR interconnection cable into the XLR connectors; see ④ in the below diagram.
Installing the phase splitter tube shield:
NOTE: This installation is optional if you do not use the RCA input.
1. Install the 12AU7 tube into the socket ②
2. Screw the tube shield clockwise into the ring of the socket.
Installing the acrylic panel on the AMP:
Installing the acrylic panel on the PSU:
Similar to the last 2 steps above.
Slightly push the plug inward Turn the ring clockwise
until you hear a click sound


There are 2 holes
near the faceplate on
the top of the AMP
unit. One is threaded
and the other is
clear.
Put the stainless
steel screw on
the threaded
hole.
Secure the
screw.
Put the panel
filler into the
panel
Put the panel
screw through
the filler then
secure it.