Woo Audio WES - Manual (Page 11)

©2011 WOO AUDIO tm Inc. All rights reserved. www.wooaudio.com Rev 1.0. June 10, 2011. 11
Operation
DO NOT
o
Turn on the amp before properly installing ALL tubes.
o
Use tubes that are not approved by Woo Audio.
o
Turn on the equipment without checking the correct AC voltage setting.
o
Remove any tubes or the DC cord while the amp is operating
o
Touch tubes (extremely hot) after warm-up.
o
Leave the amps running unattended. To use the amps safely, please allow it to
cool down for every 8 hours of continuous play time.
DO
o
Place the amp away from any wireless or frequency-emitting devices such as
mobile phones, PDAs and radios, to avoid noise interference.
o
Keep away from water or excessive moisture.
o
Turn off the amp if its sound is abnormal.
o
Allow a minimum of 2 inches of air clearance for heat dissipation.
o
Allow approximately 5 minutes of warm-up.
o
Allow the tubes to cool down before replacing them.
Turning the amplifier on:
1. Turn the volume knob to the lowest position.
2. Insert a headphone into headphone output
3. Turn the standard-by power switch knob ⑤ from left to right until you hear a
clicking sound. The LED ⑦ will light.
4. Observe that all tubes light gradually.
5. Let the tubes warm up for at least 1 minute.
6. Turn the power switch knob ⑥ from left to right until you hear a clicking sound.
7. The amplifier is now in operation.
NOTE: The amplifier will not function until both power switches are turned on.