Wilbur Curtis CGC - Manual (Page 2)

2
1. Brewer should be ON (confirm at the rear toggle switch). When a screen saver is running, touch the screen to restore the control screen.
This screen should read Ready to Brew.
2. Place an empty cup under the brewcone.
5. Slide the filled brewcone into the brew
rails on the brewer.
3. Place a clean filter into the brewcone. 4. Fill brewcone with the proper amount of
ground coffee.
COFFEE BREWING INSTRUCTIONS
WARNING TO AVOID SCALDING, Do not remove brewcone while brew light is flashing.
6. Start the brew cycle by hold your finger
on the desired brew icon. As soon as
you hear the click of the brew valve, the
brew cycle has started and you can lift
your finger.
Brew Code: You may find that when a brew
button is pressed, a key pad appears on the
screen. This is a brew lock-out feature that
requires a code to be entered before a brew
will start. The default is OFF.
CAUTION: When enabled, as soon as you
enter the brew code a brew cycle starts.
Refer to page 8 for more information about the
Brew Code.
During the brew cycle, an animated coffee
cup icon will appear on the screen and a
brew timer will count down the time remain-
ing on the brew cycle.
Your Curtis Gold Cup Series is Factory Pre-Set for Optimum Performance.
After connection to water and power; turn on the brewer at the rear toggle switch. You will hear a beep and the status lights will come on for a moment.
The screen will display . Next is displayed. Water will fill the tank (2-3 minutes depending on water flow rate).
When the proper level is reached will appear on the screen. It takes approximately 30 minutes to reach the set point temperature.
Control will display when temperature reaches the set point. The unit is now ready to brew.
MODEL NUMBER
CONTROL BD NUMBER
READY TO BREW
HEATING
FILLING