Connecting odm devices to your pc – Chemtronics VIS 400-HDP Fiber Inspection Scope User Manual
Page 6
Optical Design Manufacturing VIS Image Manager Software Manual
Page 6
v1.3.6
Installation of FTDI Chip Driver for the ODM RP-460
To install the FTDI Chip Windows driver for the RP-460, navigate to the FTDICHIP folder of
the CD included in the installation package and double-click on CDM20824_Setup and follow
the installation instructions.
Installation of Videology Driver for the VIS-300 and VCM-410
Both ODM VIS 300 and VCM 410 require a Videology Windows driver for proper operation. If
the serial number on the VIS-300 or VCM-410 has a “C” appended to the end, navigate to the
Videology/Windows 32-64-bit Cypress folder of the installation package and double–click on
SetupVid and follow the installation instructions.
If there is no “C” after the serial number, then go to web page
and download the SFT-04040 Windows driver and
follow the installation instructions.
Connecting ODM Devices to Your PC
VIS 300
Connect the ODM VIS 300 or VCM 410 to a USB port on your PC using the supplied USB
cable. Wait for Windows to load the driver you installed in the section above. You should see
Windows report a message indicating the Videology Camera driver loaded successfully.
RP-460
Connect the ODM RP 460 power meter to a USB port on your PC using the supplied USB cable.
Wait for Windows to load the driver you installed in the section above. You should see Windows
report two messages indicating the drivers loaded successfully.