Canon Digital Video Camcorder ZR20 - Manual (Page 76)

76
E
Editing
Copyright signal
Certain pre-recorded software tapes are copyright protected. If you try to play
back such a cassette, “COPYRIGHT PROTECTED PLAYBACK IS
RESTRICTED” appears in the display for a few seconds and then the camcorder
displays a blank blue screen; you cannot view the contents of the cassette.
If you try to record from such a tape via the digital cable “COPYRIGHT
PROTECTED DUBBING RESTRICTED” appears in the display; you cannot
record the contents of the tape.
1. Find a point on your recorded cassette slightly before the section
you want to copy and set it to playback pause mode.
2. Press the camcorder’s REC PAUSE button.
• The camcorder enters record pause mode.
3. Start playback on the other digital device while you monitor the
picture.
4. Press the pause button.
• Recording starts.
5. When you get to the point where you want to stop recording, press
the stop button or the pause button.
• Recording stops.
6. Stop playback on the other device.
Notes:
• If the cable is not connected properly, or if the cable is unconnected when you
press REC PAUSE, the camcorder displays the caution ‘‘CHECK THE DV
INPUT.’’ An anomalous image may also flash onto the screen.
• Blanks between recordings on the playback tape are recorded as anomalous
images on the tape that is being recorded to.
• During DV dubbing you cannot add digital effects.
Dubbing
4_ZR20_E(74-87) 3/12/01 17:38 Page 76