General – Axesstel TX240G User Manual
Page 18
18
SETTING CONNECTION ALERT
If enabled, a discrete tone is generated on the receiver when a call is connected.
To change the setting:
1. Pick up the handset.
2. Press
□
*
□
*
□
1
□
5
□
# to enable the feature.
3. Press
□
*
□
*
□
1
□
5
□
* to disable the feature.
NOTE: The default setting may depend on the service provider.
GENERAL
SETTING CALLER ID MODE
If your phone connected to the terminal is caller ID enabled, you can set the terminal to display
the caller identification number or name on the LCD display of the wired or cordless phone.
To change the setting:
1. Pick up the handset.
2. Press
□
*
□
*
□
2
□
1
□
0
□
# to disable the Caller ID feature.
3. Press
□
*
□
*
□
2
□
1
□
1
□
# to enable DTMF Standard type.
4. Press
□
*
□
*
□
2
□
1
□
2
□
# to enable FSK (Bellcore) type.
NOTE: The default setting of Caller ID is FSK.
CALL WAITING ID
The Call Waiting ID feature allows the display of the second caller’s number while already in a
conversation (call waiting). This feature works only with FSK Caller ID setting. In order to use this
feature, the corded/cordless phone must support caller ID and call waiting ID, also known as type II
caller identification.
CALLER NAME DISPLAY
This feature allows the display of the caller’s name on the corded or cordless phones that support
alpha-numeric display for caller name display. This is a network dependent feature and works only if
your service provider supports it. This feature may require an upgrade to premium service or an
additional fee.