Rane Via 10 - Manual (Page 19)

Manual-19
SetMicActive(Mic, Value) Sets a Mic’s Active Setting
SetMicSigMode(Mic, Value) Sets a Mic’s Signal Mode Setting
SetMicGateMode(Mic, Value) Sets a Mic’s Gate Mode Setting
SetMicGateDepth(Mic, Value) Sets a Mic’s Gate Depth
SetMicAutoThreshold(Mic, Value) Sets a Mic’s Auto Threshold Setting
SetMicThresholdLevel(Mic, Value) Sets a Mic’s Threshold Level
SetMicGateRelease(Mic,Value) Sets a Mic’s Gate Release Setting
Events:
OnOpstats Opstats updated from ECB 6
OnParams Parameters updated from ECB 6
Initialization:
Set_Controller ( Via10RW232X)
Must be called for each Via10 RW 232 ActiveX control as the argument to
begin communication. This must be called for each RW 232 device in the
system – where
Via10RW232X is replaced with the name of each RW
232 ActiveX control inserted into FrontPage. See example 1 above.
RPE 228d ActiveX control
Control Name: Via10RPE228X
Description: Allows control of any RPE 228 or RPE 228d connected to a Via 10. See “RW 232 Device Control Language”,
available in PDF form in the Library at
www.rane.com for parameter value details.
Design Time Parameters:
Addr RW 232 Address (1-250)
OpstatFreq Milliseconds between Opstat updates
Runtime Parameters:
Memory Reflects the current memory selected in the RPE 228
Ch1InGain Channel 2’s Input Gain
Ch1OutGain Channel 2’s Output Gain
Ch1Mute Channel 2’s Mute
Ch1LowCut Channel 2’s Low Cut Setting
Ch1HighCut0 Channel 2’s High Cut Setting
Ch1ByPass Channel 2’s Bypass
Ch2InGain Channel 2’s Input Gain
Ch2OutGain Channel 2’s Output Gain
Ch2Mute Channel 2’s Mute
Ch2LowCut Channel 2’s Low Cut Setting
Ch2HighCut0 Channel 2’s High Cut Setting
Ch2ByPass Channel 2’s Bypass
Events:
OnOpstats Opstats updated from RPE 228
OnParams Parameters updated from RPE 228
Initialization:
Set_Controller ( Via10RW232X)
Must be called for each Via10 RW 232 ActiveX control as the argument to begin communication.
This must be called for each RW 232 device in the system – where Via10RW232X is replaced with
the name of each RW 232 ActiveX control inserted into FrontPage. See example 1 above.