Assembly of the front arm onto gear box – OFNA Racing Ultra MBX Pro User Manual
Page 12
Assembly of the right and left hand side
are the same.
Assembly of the right and left hand side
are the same.
36901
Ball Type
Knuckle Arm
( Right and Left )
R
* Use 5mm
hex wrench.
36903
13.8mm
Steering Ball
36905
Steering Ball
Washer
36904
14mm
Alum. Nut
* Adjust alum. Nut to
keep steering ball
smoot.
* Note the "R" mark
is for righthand side.
R
36053
8x16mm
Ball Bearing
36053
8x16mm
Ball Bearing
36052
CVA
Universal Joint
36870
4 x 10 mm
Set Screw
* A 4 x 10mm set screw is used
to adjust the ride height.
* Approx 3mm.
36870
4x4mm
Set Screw
36890
Front
Lower Arm
36900
Front
Upper Arm
3mm
3.5mm
R
36055
2.5 x 17mm
Pin
36054
Wheel Hub
( Alum. ) blue
* Use 2.5mm
Hex Wrench.
ASSEMBLY OF THE FRONT
PIVOT BALL KNUCKLE ARM
ASSEMBLY OF THE FRONT KNUCKLE ARM
INTO FRONT ARM
0
1
Assembly of the right and left hand side
are the same.
30102
Front Body
Post
3x8mm
Tapping Screw
3mm
E-Ring
30151
Front Lower arm
Rod
90021
3mm
E-Ring
R
R
* Insert drive shaft
before assembly.
4 x 10mm
Tapping Screw
3 mm E-Ring
5 x 5mm
Set Screw
* Do not over tighten
5x5mm set screw.
5x5mm
Set Screw
ASSEMBLY OF THE FRONT ARM ONTO GEAR BOX
90021