Pigtronix Rototron - Manual (Page 8)

CHAPTER 3. GETTING STARTED 7
3.2 Guided Tour
The following steps guide you through the sonic palette of the Rototron
and show you how to get at the full range of tones it has to offer.
1. Set all of the knobs at 12 o’clock.
2. Press the Slow/Fast (left) footswitch so that the LED under the
knob labeled Slow is lit-up.
3. Press the right footswitch so that the engage LED is off. The
Rototron is in bypass mode.
4. Be sure to turn the volume knob on your guitar all the way up.
Play your instrument and make sure a clean sound is passing
through.
5. Push the right footswitch to turn on the effect. Explore the
range of the Depth knob.
6. Press the left footswitch to transition to the Fast setting.
7. Set the Fast knob to 3 o’clock and the Slow knob to 9 o’clock.
Press the left footswitch again to transition back to the slow
setting.
8. Turn the Ramp knob fully counter-clockwise, then hit the left
footswitch. Notice the near instantaneous change from slow to
fast.
9. Turn the Ramp knob fully clockwise, then hit the left footswitch.
Notice the long steady change from fast to slow. As you can
hear, the lower and upper rotors slow down and speed up at
different rates.
10. Enjoy your Rototron!