Cybex TWINYX - Manual (Page 35)

35
• Slightly fold the stroller to reduce tension.
• Remove the canopy from the stroller, if
attached.
• Remove the seat cover hooks (3) from
both sides of the frame.
• Open the press buttons (4) of the two
straps connecting the seat side panels
with the rear tube.
• Open the flaps (5) which are fixed with
velcro covering both sides of the seat
tube fixed underneath the seat unit.
• Feed the strap with the slider (6) of the
central harness buckle through the hole
in the seat fabric.
• Feed the loops at the end of the shoulder
straps through the triangle in the backrest
(7).
• Feed the shoulder straps through the holes in the seat fabric (8).
• Open the press buttons on the left and the right side of the seat unit. These are fixed at
the underside of the seat unit.
• Pull the seat cover over the harness adjustment button of the seat.
• Slide the fabric from the seat base tubes.
• Reverse this procedure to refit the seat cover and the harness. Make sure that the seat
tubes slide back into the pockets inside the seat cover.
12. REMOvING THE SEATCOvER
a)
EN