Obihai OBiTALK Portal Device Management (SIP & Google Voice) - Manual (Page 4)

Copyright 2010-2011 Obihai Technology, Inc. 4
Primary Line to Call Out:
By default, OBi devices which come with an analog (PSTN) line port will use this as the Primary Line
for outbound calls. This means that when you make a new call using the OBi Attendant, you do not
need to first dial a service route access code.
Up to two (2) SIP-based VoIP or Google Voice Internet phone services can be added to an OBi. You
can make one of these services the Primary Line for outbound calls. The OBiTALK Service Provider
set-up screen gives the user the option to select either service 1 or 2 as the Primary Line.
When you want to make a call via a service that is not the Primary Line, you will need to dial that
service’s access code before the destination number.
The service route access codes are defined as:
* * 1 : Voice Service Provider 1 (SIP or Google Voice)
* * 2 : Voice Service Provider 2 (SIP or Google Voice)
* * 8 : LINE Port (PSTN) Service Provider
* * 9 : OBiTALK Network
Voice Service Configuration
To set-up a BYOD service on the OBi, select the Service Provider 1 or 2 to edit the settings.
You will then be presented with a list of providers with which to configure Internet voice services on
your OBi. Use the e-mail or web-page configuration settings provided by by the Internet voice
service provider in the service provider specific configuration templates provided.
Note: If a service has been previously set-up, you will see the name of the service next to the
“Service Provider x” label and a red “
X ”. If you want to remove the service from the OBi device
configuration, select the red “ X ” and confirm the removal of the service. When this is submitted,
the OBi device will reboot and the Service Provider settings will be cleared. The OBi is then ready for
another service to be configured on that SP line.
As of this writing, below are the Internet voice service provider templates from which to choose: