Talkaphone ETP-GSM GSM Cellular Interface - Manual (Page 4)

ETP-GSM
– Cellular Interface
Installation Instructions
Page 4 of 10 Rev. 12/16/2014
Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement, sponsorship, or affiliation
with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
2. The rear panel of the ETP-GSM Cellular Interface provides the following:
(1) Input terminal for 12VDC;
(2) Connector for remote-mounting omni-directional antenna;
(3) A serial port (for Talk-A-Phone Technical Support purposes only).
Figure 3. Rear panel of the ETP-GSM Cellular Interface.
3. Using the supplied Torx T10 L-Key, remove the Torx T10 screws from the rear panel (i.e. the panel with
the 12VDC, antenna, and FXS connectors).
4. Carefully slide out the electronic board from the ETP-GSM Cellular Interface chassis.