Chauvet DMX-55 DMX - Manual (Page 15)

Operating Instructions
DMX-55 User Manual 15
2006-01-11 11:59:07
D E L ET E AL L C H AS E S
Action

1) With the power off, press and hold the
AUTO/Del and BANK

buttons.
2) Turn controller back on and all chases
will be cleared.
Notes

Playback (Scenes)
M AN U AL R U N SC EN E
When power is first turned ON, the controller will be in manual scene mode.
Action

1) Make sure neither Music nor Auto
LEDs are on.
2) Select the program BANK that stores
the scene you want to run manually by
using the BANK UP/DOWN.
3) Press the SCENE button to run.
Notes

If by chance you are in programming mode you can
also press and hold the PROGRAM button until the
Program LED goes off.
R U N N I N G I N SO U N D - M O D E
Action

1) Press the Music/Bankcopy button until
the Music LED turns on.
2) Change BANK programs by using
BANK UP/DOWN buttons if necessary.
3) Press the Music/Bankcopy to exit.
Notes

In the Sound mode, programs will be triggered by the
sound using its built-in microphone. All scenes in a
Bank will chase.
R U N N I N G I N AU T O - M O D E
This mode allows you to run a bank of programmed scenes in sequence.
Action

1) Press the AUTO/Del button until the
Auto LED turns on.
2) Change BANK programs by using
BANK UP/DOWN buttons if necessary.
3) You can adjust the time between steps
by moving the SPEED fader and the
duration of the step by moving the
FADE TIME fader.
4) Use the TAP/Display button to set the
speed instead. The time between two
sequential taps sets the speed.
5) Press the AUTO/Del button to exit
mode.
Notes

In the Auto mode, programs will be triggered by
controllers fade and speed time as set on the faders.
All scenes in a Bank will chase.
CAUTION! The fade setting should never be slower
than the speed setting or the scene will never
complete execution.
These settings will stay until the speed slider is
moved.
B L AC K O U T
The Blackout button brings all lighting output to 0 or off.