Midi operation, Data transfer, Peration – Chauvet DMX-55 DMX User Manual

Page 17: Ransfer

Advertising
background image

Operating Instructions

DMX-55 User Manual

17

2006-01-11 11:59:07

Midi Operation

The controller will only respond to MIDI commands on the MIDI channel which it is set to full stop. All

MIDI control is performed using Note on commands. All other MIDI instructions are ignored. To stop a

chase, send the blackout on note.

Action

1)

Press and hold the MIDI/REC button for
about 3 seconds.

2)

Select the MIDI control channel (1~16)
via the BANK UP/DOWN buttons to set.

3)

Press and hold the MIDI/REC button for
3 seconds to save settings.

4)

To release MIDI control, press any other
button except the BANK buttons during
step 2.

Notes


This is the Channel that the controller will receive
MIDI note commands.

MIDI

NOTE

F

UNCTION

(TURN

ON/OFF)

00 to 07

Scenes 1~8 in BANK 1

08 to 15

Scenes 1~8 in BANK 2

16 to 23

Scenes 1~8 in BANK 3

24 to 31

Scenes 1~8 in BANK 4

32 to 39

Scenes 1~8 in BANK 5

40 to 47

Scenes 1~8 in BANK 6

48 to 55

Scenes 1~8 in BANK 7

56 to 63

Scenes 1~8 in BANK 8

64 to 71

Scenes 1~8 in BANK 9

72 to 79

Scenes 1~8 in BANK 10

80 to 87

Scenes 1~8 in BANK 11

88 to 95

Scenes 1~8 in BANK 12

96 to 103

Scenes 1~8 in BANK 13

104 to 111

Scenes 1~8 in BANK 14

112 to 119

Scenes 1~8 in BANK 15

120

Chase 1

121

Chase 2

122

Chase 3

123

Chase 4

124

Chase 5

125

Chase 6

126

BLACKOUT

Data Transfer

It is possible to transfer the programs stored in one DMX-55 controller to another. Connect from the

DMX output of the programmed controller to the DMX input of the other.

Action

1)

Source unit: Turn unit Off, press and
hold SCANNER buttons 2, 3 and
SCENE button 1 then turn unit back On.

2)

Destination unit: Turn unit Off, press
and hold SCANNER buttons 8, 9 and
SCENE button 2 then turn unit back On.

3)

Both units are now ready to transmit
and receive. Press SCENE buttons 7 &
8 simultaneously on Source unit to
begin transmission.

Notes

The display should show TRANSMIT, this indicates it
is ready to transmit data.

The display should show RECEIVE, this indicates it is
ready to receive data transmission.

Advertising