Talkaphone PBX-64 - Manual (Page 2)

PBX-64 Analog and IP Phone System Installation
Copyright 2009 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Page 2 of 5
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
6. Install the IX-408 card into slot #1 of the IX-CME cabinet. If there is more than one IX-408 card,
install them into the subsequent slots. Make sure that the card is inserted deep enough for all
connector pins to make complete contact with those on the backplane motherboard.
7. Install the “KT” punchdown block:
a. Route the 25-pair cable through the cable raceway.
b. Plug the 25-pair male amphenol connector from the “KT” punchdown block into the IX-408
card with the corresponding port number. If applicable, repeat for each successive “KT”
punchdown block.
8. If an IX-MBU does not need to be installed, skip to step (9).
If installing an IX-MBU (model PBX-MBU) card into the IX-CME:
a. For systems with one IX-408 card, slide the card into slot #2. For systems with more than
one IX-408 card, slide the card into the slot immediately following the last IX-408 card.
b. Make sure that the card is inserted deep enough for all connector pins to make complete
contact with those on the backplane motherboard.
c. Secure the card stopper bracket with the two screws provided if no other cards are to be
installed.
d. Using the Unshielded Twisted Pair (UTP) straight-through cable (provided with the IX-MBU),
connect the CCU port on the IX-MBU card to the LAN2 port on the IX-CCSU card.
e. Connect the LAN port on the IX-MBU card to the Local Area Network (LAN).
f. If there are analog (IX-8SUBS-3) cards to be installed, continue onto step (9). Otherwise,
continue onto step (10).
9. If installing an IX-8SUBS-3 (model PBX-8MB) card into the IX-CME:
a. The system may have shipped with IX-8ESUBS (model PBX-8DB) daughterboards to
provide additional analog port capacity. If so, mount the IX-8ESUBS daughterboard onto an
IX-8SUBS-3 card using the CN1 and CN2 connectors. Each IX-8SUBS-3 motherboard can
support up to one (1) daughterboard. All daughterboards must be mounted to a
motherboard.
b. When installing the IX-8SUBS-3 cards, it should be noted that cards without daughterboards
should always be grouped to the right of cards with motherboards. That is to say, install the
motherboards with daughterboards first, and then proceed with installing the motherboards
without daughterboards.
For systems with more than one IX-408 card and without an IX-MBU card, slide the IX-
8SUBS-3 card into the slot immediately following the last IX-408 card. For systems with an
IX-MBU card, slide the IX-8SUBS-3 card into the slot immediately following the IX-MBU.
c. Slide any additional IX-8SUBS-3 cards into subsequent slots.
d. Make sure that the card is inserted deep enough for all connector pins to make complete
contact with those on the backplane motherboard.
e. Secure the card stopper bracket with the two screws provided if no other cards are to be
installed.