Talkaphone PBX-64 - Manual (Page 4)

PBX-64 Analog and IP Phone System Installation
Copyright 2009 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Page 4 of 5
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
VII. Programming a VOIP-1-2-4-8 Interface Unit for the PBX System
Aside from the general VOIP-1-2-4-8 programming, there are considerations that need to be made specifically for
operation with the PBX System.
Note: Make sure to click on OK to temporarily save changes in a specific programming section before clicking on a different section
in the navigation tree in the left column.
Once programming has been completed on the VOIP-1-2-4-8, click on Save & Reboot in the navigation tree and click on OK.
Any programming changes may be lost if you do not keep these notes in mind.
Phone Book Configuration:
1. Check or enable the Register with Gatekeeper option.
2. Under “Gatekeeper RAS Parameters” section, set the “Gatekeeper IP Address” to the
LAN2 IP address of the PBX. Set the “Port Number” to 5060.
3. Under the “SIP Parameters” section, set the “SIP Signaling Port” to 5060. Check or
enable the Enable SIP Proxy option.
4. Under the “Proxy Parameters” section nested inside the “SIP Parameters” section, set
“Proxy Domain Name / IP Address” to the LAN2 IP address of the PBX. Set the “Port
Number” to 5060. Set “Re-registration Time” to 30 seconds.
Inbound Phone Book Entry:
1. The Inbound Phone Book for the VOIP-1-2-4-8 describes the dialing sequences required for a call
to originate remotely from any other VOIP-1-2-4-8, Attendant Phone, or Emergency / Information
Phone on the PBX system. In other words, the Inbound Phone Book is used to assign a number
to each local channel on the VOIP-1-2-4-8 Interface Unit. Each channel needs to be assigned
the appropriate SIP extension that was specified on the PBX Planning Form submitted at time of
order. Enter the assigned extension into the “Remove Prefix” field.
2. Check or enable the Register with SIP Proxy option. Registration is required by an IP
“SLT” on the PBX system.
Outbound Phone Book Entry:
1. Check or enable the Use as default entry option. The “Destination Pattern” field
will now be labeled as “Any Number”. This option will allow the Emergency / Information Phone
connected to the VOIP-1-2-4-8 Interface Unit to dial any extension on the PBX system. If you
wish to restrict the outbound dialing from the VOIP-1-2-4-8, then uncheck or disable the Use as
default entry option and set the “Destination Pattern” to a specific extension.
2. Set “Total Digits” to the number of digits that the Emergency / Information Phone will dial.
3. Set the “IP Address” to the LAN2 IP address of the PBX.
4. Select SIP for “Protocol Type”.
5. Under the “SIP” section, select UDP and set the ”SIP Port Number” to 5060.