Talkaphone PCS-84-10 Power Charging System (84 Ah) - Manual

PCS-84-10
Installation Instructions
Copyright 2012 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
Rev. 11/12/2012
I. Introduction
This manual is for a Power Charging System designed to provide power during the day to a Talk-A-Phone Co.
Emergency Phone System that receives power every night. At night, while the batteries are being charged, the
Power Charging System will continue to power the system.
The PCS-84-10 is specifically designed to provide power to a Talk-A-Phone tower enclosure (ETP-MT/R-PCS, ETP-
MT/R-PCS-WP, ETP-MTE-W, ETP-MTE-WP, WEBS-MT/R) or surface mount enclosure (ETP-SMW).
II. Contents
Before beginning installation, make sure you have all the included components. Each PCS-84-10 package consists
of the following bill of materials as summarized below:
Qty. Part Number Description
1 86401 Battery Charger - 12VDC, 10A
2 68594 Battery - 42Ah
6 67524 Battery Terminal Connectors – Ring, 1/4in, Crimp
4 4247 Screw - #8-32 x 0.5 L, Binder Head, Slotted
4 4248 Nut - #8-32, Hex, Machine
4 42767 Washer - External Tooth Lock Washer, # 10
III. Communication System Installation
All connections must meet National, Regional and Local Electrical Codes. Installation should only be performed by
qualified professional personnel. Step down transformer and DC-DC converters (included with the cellular
interfaces), have connections for multiple input and output voltages. Be sure to make your connections to the
terminals labeled with the voltage that you require. As a safety precaution, it is recommended that you make all
connections while the 120VAC (or other high-voltage) is turned off. The battery may need one charge cycle before
the system will function completely. It may be convenient to charge the battery in advance.
Make all electrical connections according to the wiring schematic in Figure1 as well as any instructions included
with the individual electrical components:
1. Use battery terminal crimp-on connectors to connect the LED Blue Light and LED panel light assembly
directly to the battery.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED
CE
PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION
PERTINENT, PAR UNE PERSONNE QUI CONNAÎT BIEN LES PRODUIT ET
SON FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS