Pcs-84-10 installation instructions – Talkaphone PCS-84-10 Power Charging System (84 Ah) User Manual
Page 3
PCS-84-10
Installation Instructions
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
Page 3 of 3
A. Installing inside a Box Enclosure (PCS-BOX Series)
1) The mounting panel of the PCS-BOX is aluminum to allow for the installer to mount the PCS-SD Series
Step-down transformer (sold separately) and the battery charger where desired.
2) The DC/DC Converter for the ETP-CI device should be affixed to the back panel using the included dual lock
strips. The battery should be placed in this enclosure as well.
3) If a cellular interface (model ETP-CI) or a wireless IP interface (VOIP-RF-FM-1100) models are included in
this installation, it may be convenient to place this equipment in the same enclosure depending on the phone
mount chosen.
B. Installing inside a Tower Enclosure (ETP-MTE-W / ETP-MTE-WP / ETP-MT/R-PCS / ETP-MT/R-PCS-WP,
WEBS-MT/R)
1) The battery charger, DC/DC Converter and optional step down transformer mount on to the aluminum
mounting panel provided inside the tower.
2) The ETP-CI device can either be mounted on the mounting panel provided inside the tower (ETP-MTE-W /
ETP-MTE-WP) or the weld studs provided behind the emergency phone (ETP-MT/R-PCS / ETP-MT/R-PCS-
WP).
3) Mount the antenna on to the tower top cap plate by removing the plug covering the hole.
C. Installing inside a Wireless Surface Mount Enclosure (ETP-SMW)
1) The battery charger, DC/DC Converter, cellular interface (ETP-CI) and optional step down transformer
mount on to the aluminum perforated mounting panel provided inside the enclosure.
2) Pass the antenna cable through the hole/knockout on bottom or back for conduit in the case of mounting the
antenna remotely.
Figure 2.
Typical installation of ETP-MT/R-PCS, exploded and fully assembled with 1)
battery charger, 2) mounting panel, 3) cellular interface, 4) DC/DC converter, 5) battery
shelf, 6) battery, 7) step-down transformer