Warpia SWP200 Windows Installation Manual & Troubleshooting Guide - Manual (Page 35)

Wireless USB DisplayDock Set User Guide
Page 35
Problem/Question Symptoms Solution
Audio is not synchronized
with the video When you play a video, the audio part of the
playback may not be synchronized with the video
playback. Change the active power plan to
‘Always On’ or to ‘Balanced’ or to
‘High Performance’.
XP: Click Start, select Control
Panel. Click Power Options.
Under Power Schemes select
Always On.
Vista: Click Start, type power in the
Start Search box, and then click
Power Options in the Programs list.
Under Select a power plan, click
Balanced or click High
performance.
No Audio on the remote
speakers connected to the
Easy Dock When you play a video and the audio part of the
playback is heard from the PC speakers and not
from the remote speakers. Make sure you have connected the
remote speakers to the 3.5mm audio
port.
On the media player press Stop and
then Play to restart the video. Please
see Sec. 5.5 Setting Audio Output
Device for further details.
Problems in establishing
connection with Device
(red) icon in System
Tray
To check if a device is connected, right click the
System Tray icon and select Wireless USB
Manager to view the list of available devices
and to see the green Connected
icon next to the
device name of the newly established connection
- Green System Tray icon does not light
up to indicate that a connection has been
established,
OR
- The Device is not listed in the Wireless USB
Manager screen
Power not connected to Device:
ensure that the correct power supply is
connected to the device side.
Device Adapter requires restart:
detach and re-attach the Device
Adapter from the Table Adapter to
restart the hardware.
Wireless Device is out of range: if
you experience frequent Wireless link
disconnection, the Wireless Device
may be out of range –the solution is to
bring the Wireless Device closer to the
Wireless USB Host.
Device Adapter requires pairing:
if you are adding a Device Adapter that
was not part of a set, or if you are
connecting to a new unrecognized
Host, you may need to perform the
Pairing procedure see
Appendix B: Pairing Procedure