C. Crane CWFR - Manual (Page 24)

Configure Menu Options
Page 24 CC WiFi
<Language>
Allows you to change the display language.
If the firmware upgrade is interrupted, your radio may endure
permanent damage. A firmware upgrade may take several minutes to
finish.
<Reset Factory Defaults>
This option puts all settings back to their default, as they were when
the radio left the factory. If you perform a factory reset on your radio,
you will lose all your presets, clock settings, and wireless network
connection settings.
<Get Registration Key>
This option will display a key that can be used to register the radio on
the Reciva Customer Portal.
<Backlight Settings>
Selecting this option will alter the Internet radio’s backlight values.
1. After selecting the “Backlight” menu item, the radio will show
three backlight adjustment modes: “Inactive”, “Active”, and
“Standby”. These three settings are explained below:
a) The “active” state is when the user is pressing buttons or
turning knobs.
b) The radio goes into its “inactive” state when there is no
user activity for 30 seconds.
c) “Standby” is the state when the radio has been turned off.
2. Rotate the dial to select the desired backlight mode — press the
dial to select.
3. The radio will display the current backlight value for the selected
mode. You can change this value by turning the dial to increase or
decrease it.
<Clock Set Up>
Use this option to set the time, date and clock format. See “Setting
the Time and Date” on page 15.
<UPNP>
Use this option to set a name for your radio that can be recognized by