C. Crane ATS-909X - Manual (Page 36)

1. LINE-OUT JACK
The Line-out jack, is used to output the audio from the ATS-909X
to another device such as a recorder, your home stereo, or some
other units. To do this, you will need a 1/8" stereo patch cord.
Warning:
If a “Line-out” is not available on your external audio source,
you can use the headphone jack. However, the volume must be
kept low or damage to the ATS-909X may result.
34 35
Note:
The Line-out jack differs from a headphone jack because the
volume level of a headphone jack varies depending on the volume
of the radio. The Line-out jack has a set line level so the volume
is consistent no matter what the position of the volume knob.
1) Plug your patch cord into the Line-out jack on the ATS-909X.
2) Plug the other end of the patch cord into the Line-in or Audio in
of the device you want to send the audio to and you will hear the
radio through the other source. You can still listen to the
ATS-909X while using the Line-out jack.