C. Crane BC345CRS - Manual (Page 18)

18
display shows the initial clock time of 12:00 AM. The scanner remains in
STANDBY mode.
CONNECTINg AN ANTENNA
The scanner uses an external loop antenna
to receive AM broadcast stations and an
external telescopic antenna to receive all
other signals. Connect the supplied rod
antenna by pushing the antenna’s
connector onto the antenna jack on the
back of the scanner and twisting it to the
desired angle. Connect the two wires
from the loop antenna to the AM RADIO ANT terminals on the back of the
scanner.
You can also use an external antenna (not supplied) to help to bring in
weaker signals. Use RG58, 50-Ohm lead with a BNC connector to connect
the antenna to the scanner. Connect and mount the antenna according to the
instructions provided with the antenna.
CAUTION: Be sure to follow all safety warnings provided with the antenna.
Failure to do so could expose you to risk of injury or death and could severely
damage the scanner.
USINg THE BACKLIgHT
To turn on the backlight for 15 seconds, tap
SNOOZE/Light
. To turn
on the backlight permanently, press and hold
SNOOZE/Light
for
over 2 seconds. To turn off the backlight, press and hold
SNOOZE/
Light
again.