C. Crane BC345CRS - Manual (Page 22)

22
BANK 1 BANK 2 BANK 3
4 54 104
5 55 105
6 56 106
7 57 107
8 58 108
9 59 109
10 60 110
Follow these steps to enter or change a frequency in a memory:
1. Press
E/PgM to enter the Program mode (the scanner turns on the PGM
icon).
2. If the current channel is not the one you want to program, enter the
channel number then press HOLD.
3. Enter the frequency, including the decimal point, and then press E/PgM.
4. To program the next channel, press ▲ or ▼ and repeat step 3. To
program a different channel, repeat from step 2.
5. To exit Program mode, press HOLD or SCAN or change the scanner’s
mode.
Notes:
• Any frequency you program replaces the previous channel contents.
• If you enter a frequency you have already stored in a different channel
in Step 3, the scanner beeps and displays the channel where you have
previously stored the frequency. If you want to store the frequency
anyway, press E/PgM a second time in Step 3.
• To clear the contents of a channel, enter 0 in Step 3.
• Channels you program are automatically unlocked (see “Locking/
Unlocking Channels) and have Delay turned on (See “Setting Channel
Delay”).
SELECTINg A CHANNEL
To select a single channel to monitor, press HOLD. The scanner turns on the
HOLD icon. Then, select a channel by pressing ▲ or ▼ to go to the channel
or input the channel number then press HOLD.
SCANNINg MEMORY BANKS
To scan the channels you have programmed, press SCAN. The scanner
scans all unlocked programmed channels in enabled memory banks, stopping
on a channel when it detects a transmission. To turn on/off channel banks
while scanning, press the number button that corresponds to the channel bank
you want to enable or disable.