CANOGA PERKINS 9120 Gigabit Ethernet Media Converter - Manual (Page 11)

Canoga Perkins
9120 Gigabit Ethernet Media Converter 2-1
Chapter 2
Setup and Installation
This section details the unpacking, setup, and the options for installing the 9120 Media Converter.
Figure 4 shows the front view of the 9120 Media Converter.
Figure 4. Front View of the 9120.
2.1 Unpacking
Canoga Perkins products are carefully inspected and tested prior to shipment from the factory. It is
recommended that you keep the shipping package until the unit has been installed and verified as
being fully operational. In the unlikely event that the unit is defective, contact the Canoga Perkins
Customer Service department for a Return Material Authorization (RMA) number. For directions on
how to return the unit, refer to Appendix A.
Canoga Perkins products, like all electronic devices with static sensitive components, should be
handled with care. Since there are no user-serviceable parts inside the unit, opening the case will void
the factory warranty.
2.2 Setup of the 9120 Media Converter
The 9120 Gigabit Media Converter standalone model requires its own power source. The desktop
version of the 9120 Media Converter is supplied with a wall-mount power supply that requires 100-
240VAC at 50-60Hz and provides +5VDC to the unit. The unit can be rack mounted in the 9101
LAN Chassis. The 9120 Gigabit Media Converter rackmounted model is powered by the 9101 LAN
Chassis.
2.2.1 User Port Connection
The 9120 Media Converter features a Duplex SC multimode or single mode fiber optical connector
on the user side of the network, located on the front of the unit (Reference Figure 4). The user port is
angled to facilitate decreased fiber bend when the 9120 is mounted vertically in a 9101 chassis.