CANOGA PERKINS 9120 Gigabit Ethernet Media Converter - Manual (Page 16)

Canoga Perkins
9120 Gigabit Ethernet Media Converter 3-2
3.2.1 Canoga Remote Fault
The remote fault function applies to Extension Port only. If the extension port lost link, the media
converter will transmit a Canoga-specific Remote Fault pattern to Extension Port's transmitter.
In the diagram below, when a unit detects a link loss on the Extension Rx port, a Remote Fault pattern
will be sent to the remote unit. The unit that detected the link loss will display a red RMTF LED.
Note the DIP switch RMTF setting must be enabled (up) to activate the RMTF functionality.
Figure 12. Remote Fault Diagram.