CANOGA PERKINS 9151 Network Interface Device - Manual (Page 37)

Check LAG Data
You can check the status for each LAG and view statistics about activity on each LAG.
The Lag Configuration screen shows when the latest LAG status or configuration change occurred; it
is listed in system up-time (days, hours, minutes and seconds after last restart), rather than by date and
time.
The LAG [name] Definition screen shows LAG status.
• Port Speed: Reports actual speed or link down
• Actor Admin: Name of port
• Oper State: Current state
• Port Active: Reports if port is Active or Inactive
• LACP Activity: Active or Passive
• LACP Timeout: Long (30 sec) or Short (1 sec)
• Aggregation: Aggregatable or Individual (port can/cannot be part of a LAG)
The LAG [name] Status and Statistics screen shows information about individual ports within the
LAG.
• OperState: Shows status for [default], Aggregate or Individual port; Long or Short timeout;
Activity or Inactivity
• Partner: The remote end of the link
• LACPRx: How many frames received at this port included LACPDUs
• MarkerRx: How many frames received at this port included Marker PDUs
• MrKrspRx: How many frames received at this port included Marker Response PDUs
• UnknownRx: How many frames received at this port included an unknown PDU or are
addressed to the Slow Protocols MAC address, but do not include the Slow Protocols Ethernet
type
• IlegalRx: How many frames received at this port included a faulty PDU or protocol subtype
• LACPTx: How many LACPDUs transmitted from this port
• MarkerTx: How many Marker PDUs transmitted from this port
• MrkRspTx: How many Marker Response PDUs transmitted from this port
9151 Network Interface Device 3-23