Line data input, When line length is known), Attention – Daiwa SEABORG-1000MT User Manual
Page 13
11
Attention
1.
Do not wind the end of the line onto the spool because it causes incorrect length
calculation. Move the power lever to OFF position, and wind manually when nearing the
end of the line.
OFF
7
8.
Press
RESET BUTTON
for 2 seconds, until the display shows
800
. (500 is the default setting)
7.
Pull the lever back to the OFF position, after winding.
9.
Enter the line length with the power lever. (in the figure on the
right, line length is 1000 m).
10.
Press
RESET BUTTON
for 2 seconds and a beep will be
heard. The display should return to
0.0
, completing the setting
procedure.
If “
Err
” appears on the display, you must use the
MODE SET
BUTTON
to re-enter the data.
Line data input
(When line length is known)
8
10
MAX
OFF
9
Do not reel in the end
of the line