Citronic CL1200 - Manual (Page 7)

170.881UK User Manual
Channel Faders
25. MUTE Pressing this switch in mutes the channel output (not Insert Send)
A red LED indicates that the channel is muted.
26. PFL Pre-Fade Listen sends the channel signal direct to monitoring.
This means that the channel signal is shown on the main VU LEDs.
Also, the signal is routed directly to the headphones output.
This allows the particular channel signal to be checked.
If many PFLs or AFLs are selected, all are routed to monitoring.
A yellow LED indicates that the channel is set to PFL.
27. Channel fader 60mm fader to adjust the channel level to the master output.
A dB scale is provided to show the level of boost or cut.
12Vdc Lamp Connection
At the top of the console, a 12Vdc output is provided on a BNC connection for
a console lamp. This must be no more than 0.5A (6W)
Master Output Section
28. MON 1 OUT Balanced XLR output for
MON 1 (monitor 1)
29. MON 2 OUT Balanced XLR output for
MON 2 (monitor 2)
30. MAIN L OUTPUT Balanced XLR output for
main left out
31. MAIN R OUTPUT Balanced XLR output for
main right out
32. FX MUTE Footswitch jack to mute FX.
Connect a non-latching
footswitch here to mute or
un-mute the FX SEND signal
33. PHONES Stereo headphones output
34. PC INTERFACE USB type B connector for PC or Mac computer. The computer will detect the console as
a USB audio device (this does not require any special software driver) which can be
used to send the main mix output to PC or Mac for digital recording.
This connection can also be used for audio playback from PC or Mac by pressing in the
2TK MODE button (53). Playback level is governed by the 2TK/PC control (52)