Dynon Avionics D1 - Manual (Page 27)

Using Your D1
D1 User Guide 6-3

Press the Rocker to advance through different settings.

Move the rocker up and down to adjust a selected setting.

When you are finished, press the Menu Button again to exit the Settings Menu.
Mounting Your D1
Mount in the aircraft using one of the provided removable, portable mounts. When mounting the
D1, the following alignment constraints must be met:

A very small amount of roll install error (+/- 6 degrees) can be corrected during the software-
based alignment process.

A much larger amount of pitch (+/- 30 degrees) can be accommodated via software alignment.

For proper yaw alignment, the unit must be aligned so that the surface of the display is parallel
with the lateral axis (wingtip to wingtip) of the aircraft. In other words, the D1 must not be
pointed left or right to face you if it is not directly in front of you. Pointing the D1 left or right
will cause the attitude, turn rate, and slip/skid ball indications to be degraded.
RAM Suction Cup Mount

Attach the square RAM mount plate to the plastic D1 cradle using the included hardware.

Connect the above assembly to the suction base via the included short connecting arm.

Mount the suction cup to a surface that is capable of supporting the weight of the assembly. A
canopy or windscreen that has a minimal amount of curvature is ideal.

Loosen the knob on the arm to align the cradle so that it meets the roll, pitch and yaw
mounting criteria above.