Dynon Avionics D1 - Manual (Page 28)

Using Your D1
6-4 D1 User Guide

Tighten the knob to set the orientation of the cradle. Check that the mount and cradle are
secure.

Clip the D1 into the cradle. Start with the bottom of the D1. The D1 will positively snap into the
cradle as you press the top side in. The cradle’s wings will sit flush along the top and bottom
faces of the D1 when it is fully clipped in.

Check that the D1 is secure.

If you are using the Vehicle Power Adapter to provide continuous power to the D1, route the
wire through the channel along the bottom right of the cradle.
Pinch Mount

The pinch mount is designed to allow portable use of the D1 in an empty standard 3 ⅛” aircraft
instrument hole.

Retract the mount’s retention arms by pinching together the finger holes on the front of the
mount.

With the retention arms pinched together, place the pinch mount flush against the panel over
the instrument hole.

Let go to wedge the arms in the instrument hole.

Ensure that the mount meets the roll, pitch and yaw mounting criteria above.

Check that the mount and cradle are secure.

Clip the D1 into the cradle. Start with the bottom of the D1. The D1 will positively snap into the
cradle as you press the top side in. The cradle’s wings will sit flush along the top and bottom
faces of the D1 when it is fully clipped in.

Check that the D1 is secure.