Leica Geosystems Leica mojoXact Plus - Manual (Page 17)

Leica mojoXact Plus, System Installation 17
Connecting the
mojoXact Plus to a
third-party
terminal To connect the mojoXact Plus to a third party terminal that is ISOBUS Universal
Terminal compliant, refer to the picture below and carry out the following steps. The
following process assumes that the third party terminal has been installed in accord-
ance with its documentation.
1. Connect the cell modem antenna cable (purple plug) to the purple antenna
socket on the back of the mojoXact Plus.
2. Connect the GPS antenna cables (green and red plugs) to the green and red
antenna sockets on the mojoXact Plus.
3. Connect the mojoXact port expansion cable to the mojoXact Plus.
4. Connect the green cable of the mojoXact port expansion cable to the power
cable.
5. Connect the ISO UT cable to the third party terminal and to the red CAN port of
the mojoXact port expansion cable. Note that on some vehicles, the UT and
steering bus are the same.
6. Connect the steering controller to the proprietary BUS for steering (yellow CAN
port of the mojoXact port expansion cable). Note that on some vehicles, the UT
and steering bus are the same.
7. Connect the power cable by connecting the red wire to a permanent 12V power
supply, the yellow wire to the vehicle’s switched ignition power and the green
wire to earth.

The mojoXact Plus is a 12-volt DC (negative-to-earth) system only.
8. Route and secure all cables and wiring to ensure that there is no chafing or
rubbing, that could cause premature failure.

For further information, refer to www.virtualwrench.com.
a) Third party terminal
b) ISO UT cable
c)
Proprietary BUS for steering
d) Cell modem antenna
e) Power cable
f)
mojoXact port expansion cable
g) mojoXact Plus
h) GPS antenna
a
b
c
d
e
f
g
h