Connections/ initial setup (ready to play), Connections / initial setup (ready to play) , 9, Connections/ initial setup – Panasonic PV C1322 User Manual
Page 8: Ready to play)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connections/ Initial Setup
(Ready to Play)
Please make all cable or antenna connections before powering on.
Connecting
For ANT./Cable
Connect the cable from
Antenna/Cable to the VHF/UHF
terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on your
cable box to the VHF/UHF
terminal on the unit with a RF
cable.
WARNING:
Overtightening "Nut type" RF coaxial cables
may damage jacks. Finger tighten only.
Initial Setup (Ready to Play)
1
2
Plug the unit power cord into an
AC wall outlet.
Press Power on the remote or
unit. The unit comes on and auto
channel and clock set starts.
CH AUTO SET PROCEEDING
IN from
ANT./CABLE
0
VHF/UHF
UNIT
Settings are made
automatically. When setup is
done, this screen appears.
2/6/2002 WED 12:00PM
DSTiON
SETTING : CH 10
AUTO CLOCK SET
COMPLETED
If you use a cable box, turn it on and set it to the
Public Broadcasting Service {PBS) channel in
your time zone. If you use a DSS reciever, it
must be turned off.
If AUTO CLOCK SET IS
INCOMPLETE screen
appears, set the clock using
MANUALCLOCKSET
procedure as below.
AUTO CLOCK SET
PROCEEDING
CANCEL : PRESS STOP KEY
SET CLOCK
2/ 6/2002 WED 12;0
DST:0N
SET COMPLETED
SET
:
START
: ACT I ON
8
For assistance, please call: 1-800-211-PANA(7262) orsendemail to: consumerproducts® panasonic.com