Panasonic dvd-cp67 - Manual (Page 20)

Troubleshooting guide
Picture Pago
Picture distorted. •Some distortion is normal during SEARCH, -
No picture. •Ensure that the equipment is connected properly. 6
•Make sure the television is on. -
• Ensure the television's video input setting {e.g., VIDEO l) is correct. -
The picture shown on the •Go to the Video menu in the SETUP screen, and change ‘TV Aspect" to suit your television. 7, 16
television is not normal. You may also need to change the screen mode on the television itself.
(The sides of the picture are cut • Ensure that the unit is connected directly to the television, and is not connected through a video -
off or black bands appear at the cassette recorder.
top and bottom of the screen.) •The 4;3 TV ZOOM function is on. 15
(iDVDCPSTi The picture is • [DVD-CP67|
stretched horizontally.) Use the television to change the aspect to the correct one. 7
If your television cannot change the aspect when input is progressive
Press [PROGRESSIVE OUT] so the indicator goes out. Output will now be interlace.
•[PVD.CP67I
You cannot view progressive video if your television is not compatible. 6
iDVD-cperl •Press [PROGRESSIVE OUT] to turn progressive output off. This problem is caused by the editing 7
There is ghosting when method or material used on the DVD-Video, but should be corrected if you use interlace output.
progressive output is on.
Picture quality is poor. •Check the settings in the On-Screen Menu Icons’ Video menu. 15
|OVD-CP67| •Adjust the horizontal position In the On-Screen Menu Icons' Video menu. 15
The picture is off center when
progressive output is on.
Unit displays
"NoPLAY” •You inserted a disc the unit cannot play; insert one it can. 5
"CHECK* • Disc is dirty. Wipe the disc dean. -
“HDD" •Trouble is likely to have occurred. The number following “H" depends on the status of the unit.
-
□□ stands for a number. Reset procedure:
Press [POWER cl)] to switch the unit to the standby mode and than back to ON. Alternatively,
press [POWER tb] to switch the unit to the standby mode, disconnect the AC power supply
cord, and then reconnect it.
• If the senrice numbers fail to clear, note the service number and contact a qualified service person. -
0)
u
I
£
Television displays
|DVD-CP67i
"The progressive out is set to
"Disable””
•Go to the Video menu in the SETUP menus, and select “Enable" in "Progressive Out", 16
1DVD-CP671
"The software has a 4:3 aspect
ratio"
• Use the television to change the aspect to the correct one.
If your television cannot change the aspect when input is progressive.
Press [PROGRESSIVE OUT] so the indicator goes out. Output will now be interlace.
7
No on-screen display. •Go to Display in the SETUP menus, and select “On" for “On-Screen Messages". 16
On-screen displays (including
On-Screen Menu Icons and disc
type information screen) not
dispiayed or partialiy dispiayed. •Press [DISPLAY], and press [-^, ►] to highlight the rightmost icon, then press [A, T] to adjust
the position.
14
The disc’s menu is displayed in
a different ianguage. •Go to Disc in the SETUP menus, and select the preferred language for “Menus". 16