Panasonic NV-HD620 - Manual (Page 5)

O NTSC SELECT
Set according to the colour TV system,
NTSC P.B.; For TVs that can receive PAL
signals.
The output signal is the quasi-PAL
system.
4.43: When receiving NTSC 4.43 signals.
For TVs that can receive NTSC
4.43 signals.
3.58: When receiving NTSC 3.58 signals.
For TVs that can receive NTSC
3.58 signals.
O VIDEO IN (AV2)
Connects a video cable from a movie camera or
another unit.
© AUDIO IN (AV2)
Connects an audio cable from a movie camera or
another unit.
© Infra-red Remote Control Receiver Window
iD CVC (Crystal View Control) Indicator
This indicator is lit when the VCR is on.
Display
© V /\
Selects the required programme position (TV station)
of the VCR.
For tracking adjustment and vertical locking
adjustment.
• For manual tracking adjustment
The N/ and /\ buttons are used to adjust the
tracking when, for example, noise bars on the
picture during normal playback are better removed
manually than by automatic digital tracking control.
To return to automatic digital tracking control, press
both buttons together.
• For slow tracking adjustment
When noise bars appear during still or slow
playback, switch over to slow playback and adjust
with the V or ^ button to reduce the noise bars,
• For vertical locking adjustment
Use the \/ and /N buttons to minimize any vertical
jitter during still picture playback.
Set VCR/TV switch to VCR for using V ^ of remote
controller.
(D REC/OTR
Starts recording.
For One-Touch Recording (OTR),
0 TIMER REC
Turns the timer recording function on and off.
[3 is lit or not lit.
Once you operate the timer recording function,
normal VCR operation is not possible unless you
press this button again and release the VCR from the
timer recording standby mode.
0
STOP
Stops playback or recording.
Ejects the video cassette.
0 PLAY
Starts playback.
“O” is lit.
For the repeat playback function.
REAR
€> VIDEO IN (AV1)
Connects a video cable from a movie camera or
another unit.
0
VIDEO OUT
Connects a video cable to a TV or another unit.
0 RFIN
Connects the externa! aerial.
0 CH ADJ. (NV-HD620A only)
Adjusts RF transmitting channel AU31-43.
@ AC IN-
Connects the main power supply.
0 AUDIO IN (AV1)
Connects an audio cable from a movie camera or
another unit.
AUDIO OUT
Connects an audio cable to a TV or another unit.
0 RFOFF/TEST SIGNAL (NV-HD620A only)
RF OFF: Set to this position when the VCR is
connected to the TV via the AudioA/ideo
cable.
TEST SIGNAL OFF:
Set to this position when the VCR is
connected to the TV via RF coaxial cable
only.
TEST SIGNAL ON:
Set to this position when tuning the TV into
the VCR. The test signal is transmitted on
channel AU37 initially.
0 RFOUT
Connects the aerial terminal on a TV.
0 Video Playback Channel Selector
(NV-HD620EA only)
Selects the video playback channel.
■
C
.o
.a
b
CD
Q)
Q