Tuning the tv to your vcr, Setting the clock of your vcr, Nv-hd620a – Panasonic NV-HD620 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tuning the TV to your VCR
NV-HD620A
The VCR supplies a signal to the TV via the RF coaxial
cable on channel AU37.
It is possible to view the video picture on your TV in the
same way that you watch TV broadcasts,
If you have connected the VCR to the TV through the
video and audio input sockets, then you do not need to
follow the procedure below.
Operations
O)
.c
■4—*
0)
I
1
POWER(b/l
Turn on the TV and the VCR.
TEST
SIGNAL
OFF ON
“ Ld
To generate a test pattern, set
RF OFF/
TEST SIGNAL
to ON.
Set the TV to an unused position which you
wish to use for your video playback.
•Tune the TV until the test pattern appears on the screen.
TEST
SIGNAL
QFF^N
□E
Set
RF OFF/TEST SIGNAL
to OFF.
Note:
The test signal is transmitted on video channel AU37. If
you are encountering interference from a TV broadcast on
this video channel, you may readjust to another free
channel iAU31-43) by turning the CH ADJ. screw located
on the rear of the VCR.
When rotating the CH ADJ. screw, take care not to turn it
too far.
Note that if the CH ADJ. screw is used, then you will have
to retune your TV to the test signal following steps 2-4
above.