Selecting a character font, Press and release [ font) – Panasonic KX-P2023 User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Selecting a Character Font
• Press and release [ FONT)
You can select any one of the character fonts by pressing the FONT switch on the Control Panel.
The combination of FONT indicators show the current character font status, as shown below.
EXAMPLES
o o
ISUPEROUIET
.POWER
=PROGRAM
I SUPER QUIET
.POWER
=Courier
ISUPEROWET
.POWER
=Pres t ige
• •
P]
.POWER
PAPER OUT
=Bold PS
o
/ s.
ION LINE
ISUPEROUIET
POWER
’
paper
OUT
=Sc^pt
(O
<D
■D
5'
<D
• =light is lit.
0 =light is out
p =light is blinking.
Note:
• When the power is turned off, font will reset to default setting. If you want to save a font selection
as your default, you may do so by using the Initial Setup disk. ( os* P. 30)
• When both font indicators are off, the font commands from your software program will control
your printer.
37