Panasonic KX-FPG175 - Manual (Page 89)

FCC Information
List of FCC requirements and information
If requirsd by the telephone company, inform them
□f the following
■ FCC Registration No
(found on the rear of the unit)
■ Ringer Equivalence No
(found on the rear of the unit)
■ The particular telephone line to which the
equipment is connected
This unit must not be connected to a com operated
line If you are on a party line, check with your
local lelephone company
Ringer Equivalence Number (REN)
This REN IS useful in determining the quantity of
devices you may connect to your telephone line and
still have all of those devices ring when your
telephone number is called In most but not all
areas, the sum of the REN’s of all devices
connected to one line should not exceed five (5 □)
To be certain of the number of devices you may
connect to your line, as determined by the REN,
you should contact your local telephone company to
determine the maximum REN for your calling area
In the event that terminal equipment causes harm
to the telephone network, the telephone company
should notify the customer, if possible, that service
may be stopped However, where prior notice is
impractical, the company may temporarily cease
service providing that they
a) Promptly notify the customer
b) Give the customer an opportunity to correct the
problem with their equipment
c) Inform the customer of the right to bring a
complaint to the Federal Communication
Ccmmission pursuant to procedures set out in
FCC Rules and Regulations Subpart E of Part 60
The Telephone Company may make changes in its
communications facilities, equipment operations, or
procedures where such action is reasonably required in
the operation of its business and is not mconsislenl with
the rules and regulations m FCC Part 60 If such
changes can be reasonably expected to render any
customer terminal equipment incompatible with
telephone company communications facilities, or require
modification or alteration of such terminal equipment, or
□then/visB malenally affect ils use or performance, the
customer shall be given adequate notice in writing, lo
allow Ihe customer an opportunity to mainlain
uninterrupted service
CAUTION-
Any changes cr modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate this device
When programming emergency numbers and/or
making test calls to emergency numbers
1 Remain on the line and briefly explain to the
dispatcher the reason for the call before
hanging up
Z Perform such activities in the off-peak hours,
such as early morning or late evenings
This telephone provides magnetic coupling lo
hearing aids •
NOTE:
This equipment has been tested and found lo comply
with the limits for a Class B digital device, pursuant lo
Part 15 of the FCC Rules These limits are designed
to provide reasonable protection against harmful
interference in a residential installation This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications However, there
Is no guarantee that interference will not occur in a
particular installation If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures
— Reorient or relocate the receiving antenna
— Increase the separation between the equipment
and receiver
— Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected
— Consult the dealer or an experienced radio/TV
technician for help
This device complies with Part 15 of the FCC
Rul es Operation IS subject I d Ihe following two
conditions
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received,
including interference that may cause undesired
operation Privacy of communications may not be
ensured when using this phone
CAUTION-
To comply with FCC RF exposure requirements, the
base unit should be installed with its antenna
located at 2D cm or more from persons and handset
should be carried with the specific belt-clip provided
for the handset to ensure compliance Other non-
tesled belt-clips or similar body-worn accessories
may not comply, therefore, should be avoided
89