Panasonic SVGA Monitor/Receiver CT-36DV60 - Manual (Page 15)

Special Functions
MULTI Button
The MULTI Button can be programmed to issue
several commands at the same time.
Example: TV Power/On, VCR Power/ON, and Cable
Box Power/On.
Procedure:
1. Enter proper infrared codes for all devices before
programming. See code section.
2. Point your Remote Control Transmitter away from
all equipment remote sensors, then:
Press and
keep holding
Release after 3
seconds
Press
&
NOTE: Waiting more than 30 seconds without pressing
another button will exit the programming mode.
3. Press a maximum of 6 function buttons on the
Remote Control. Each button you press is equal to
one function. If 6 Remote button functions are
entered, all will register in the <MULfp> button
memory when the sequence is entered. When
finished, press the <Mui?fP to exit the programming
mode.
NOTE: Buttons which continuously perform a function
as long as pressed {Volume Up/Down, Channel
Up/Down, etc.) cannot be programmed; only those
buttons which perform a function when initially
pressed (Power On/Off, Mute, Direct Channel
Entry, etc.) can be programmed.
The following is a flow chart example of remote
functions that can be programmed into the ^MuErij
button:'
PRESS AT THE SAME TIME PRESS
I . . PROGRAMMING MODE
Pressing the cmultp button will now activate the VCR
Power/On, Cable Box Power/On, and the Receiver
Power/On at the same time.
-
RECALL Button
Press the RECALL Button to review:
© Audio Mode status
~ CH number or Video Input selected
Channel Caption (Station Identifier)
Clock time
Sleep Timer status
.2)______ ^
®
KXYZ
© 29
iyiDEO i:
CH3
1:00
(D ©
R-TUNE Button
Pressing the R-TUNE (RAPID TUNE) button toggles to
the previously tuned program.
PROGRAM
CURRENTLY VIEWED
PROGRAM
PREVIOUSLY VIEWED
^/7
Press Button
Press Button Again
-
14
-