Panasonic SVGA Monitor/Receiver CT-36DV60 - Manual (Page 9)

Installation
Video Monitor/Receiver Location
This video monitor/receiver is intended to be used with an optional stand. Consult your dealer for available options.
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on
the screen. Use of some types of fluorescent lighting may reduce remote control transmitter range'
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or
moisture. To insure optimum color purity do not position equipment containing magnets (motors, fans, external
speakers, etc.) nearby.
Optional External Equipment Connections
The Video/Audio connections between components can be made with shielded video and audio cables. For best
performance, video cables should be of 75 ohm type coaxial shielded cables. Cables are available from dealer or
electronic supply house.
Before you purchase any cables, check out the type of output and input connectors your various components
require. Also determine the length of cable you will need.
Power Supply Cord
MAKE SURE PLUG IS INSERTED FULLY INTO THE EMI FILTER. SEE
PAGE 7 ILLUSTRATION.
This product is equipped with a three-wire grounding type plug-a plug with two blades and a
third pin which is round. This plug will only fit into a grounding type outlet.
This is a safety feature. If you are unable to insert the plug into the outlet, contact your
electrician to replace your obsolete outlet. DO NOT DEFEAT THE SAFETY PURPOSE OF
THE GROUNDING TYPE PLUG. • .
Remote Control Battery Installation
Batteries: Use two “AA” batteries.
1. Remove the battery compartment cover on back of the remote.
2. Install the batteries in the battery compartment. (Polarity (+)
or (-) must be correct.)
3. Reattach the battery cover.
Heipful Hints:
For frequent Remote Control users, replace old batteries with
Alkaline batteries for longer life.
Precaution on Battery Use
Incorrect installation can cause battery leakage and corrosion
that will damage the Remote Control.
Observe the following Precautions:
1. Batteries must be replaced as a pair.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (Example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or
burn used batteries.
5. Battery replacement is necessary when Remote Control
reacts sporadically or stops operating the television.
Whenever you remove the batteries to replace
them, you may need to reset the Remote Control
Infrared Codes. We recommend that you initially
record the codes in the Infrared Remote Codes for
Specific Components section, prior to setting up the
remote.
-
8
-