Panasonic CF-28 - Manual (Page 21)

Dealing with Problems
(Summary)
When a problem oceurs, refer to this
be related to a software application
Panasonic Technical Support.
# Starting Up
page. The "Reference Manual" also contains detailed information. If a problem appears to
, read the software related manual. If you still cannot troubleshoot the problem, contact
The power indicator or bat­
tery indicator is not lit • Check the cable connection for the AC adaptor.
• Check to see if a fully charged battery is properly installed.
• Remove the battery pack and disconnect the AC adaptor, then connect them again.
is displayed
amni ^ *
Input your password. If you have forgotten it, contact Panasonic Technical Support.
POST Startup Error(s) is
displayed
C5^page 19
Windows startup, or an op­
eration is extremely slow PressC F9 ) in the Setup Utility *^' 3 ^ “Setup Utility”). This will restore the Setup
Utility's settings to their default values (except the password settings). Then, the Setup
Utility must be run once again for you to input the appropriate operating environment set­
tings. (The processing speed depends on the application software used, so this operation
may not cause the processing speed to increase.)
The date and time are incor­
rect j|wjrî9p5î^ №01
iWJTîîSiiQ^
You can set the date and time using the following menu.
[Control Panel] - [Date/Time]
[Control Panel] - [Date, Time, Language, and Regional Options] -
[Date and Time]
When the computer is connected to a LAN, confirm the date and time of the server.
If you continue to experience problems, the internal battery maintaining the clock may
need to be replaced. Contact Panasonic Technical Support.
This computer will not correctly recognize the date and time starting from the year 2100
A.D.
When the previous item is
not the cause
Press CF9J in the Setup Utility (([^ “Setup Utility”). This will restore the Setup
Utility’s settings to their default values (except the password settings).
Try removing all peripheral devices.
iWJnSo.w.s}20.0.01
Click [Local Disk(C:)J in [My Computer] with the right button, select [Properties], then
select [Tools] - [Check Now'].
tV/Jnd.0.w.s
Click [Local Disk(C:)] in [Start] - [My Computer] with the right button, select [Proper­
ties], then select [Tools] - [Check Now],
At start-up, press
CED
to operate the computer
in
the Safe mode.
When resuming from the
standby or hibernation
mode, does not appear
even if a passw ord has been
set in the Setup Utility
Use the Window's password as follows:
tWjDÎ9pÿî^20.0J
Set the password in [Control Panel] - [Users and Passwords], then add the check mark for
[Prompt for passw'ord when computer goes off standby] in [Control Panel] - [Power Op­
tions] - [Advanced].
mirmNmPJt
Select the account to change in [Control Panel] - [User Accounts] and set the password,
then add the check mark for [Prompt for password when computer resumes from standby]
in [Control Panel] - [Performance and Maintenance] - [Power Options] - [Advanced].
When the administrator
password is forgotten
iyijndov!^
After reinstalling, setup Windows and then set the password again.
imsSsmW')
If you have created a password reset disk page 12), a message is displayed w'hen you
fail to correctly enter the passw'ord. Follow’ the message’s instructions and set the passw'ord
again by using the passw’ord reset disk.
If you have not created a password reset disk, after reinstalling, setup Window's and then set
the password again.
21