Panasonic CQ-DF802U - Manual (Page 57)

□ Installation Procedures
First complete the electrical connections, and
then check them for correctness. page 60)
The included mounting collar 0 is designed
specifically for this unit. Do not use it to attach
any other model.
(0) Flat-head screw
{5 mm
0
x
6
mm)
@ Mounting
4 spring (L)
Insert mounting collar 0 into the dashboard, and
bend the mounting tabs out with a screwdriver.
Mounting tab
d) Mounting bolt {5 mm 0 )
Mounting spring (R)
0 Flat-head screw (5 mm^x 6 mm)
Fastening the mounting collar
The tabs to be bent vary depending on
the car. Bend them with a screwdriver
to fasten the mounting collar 0 se­
curely in the dashboard.
Dashboard
— 0 Mounting collar
Note:
• To securely install the unit, fully bend a
number of the tabs so that there is no
rattling.
• Be sure to fasten the unit securely when
ioining it with the mounting collar ©.
e
о
Note for the trim plate (g):
• Attach the trim plate after attaching the
main unit to the vehicle. Remove the
front panel to attach the trim plate.
о
e
(a) Using the rear support strap
@
Fire wall of car
0 Tapping screw /
(5mm<^x16mm) / 3 mm^
0 Hex. nut
(5 mm
0
)
3
) Rear support
strap
® Mounting bolt
(5 mm 0 )
Mounting collar
Attach the mounting springs 0,0 to the unit.
Secure the rear of the unit.
After fixing mounting bolt (D and power connector
®, fix the rear of the unit to the car body by either
method (a) or (b) shown below.
Insert trim plate ®.
After installation, recon­
nect the negative
0
bat­
tery terminal.
(b) Using the rubber cushion (option)
Rear support bracket
Rubber cushion (option) (provided on the car)
0 Mounting bolt
(5 mm 0 )
0 Mounting collar
CQ-DF802U
57