Panasonic CT-3696VY-1 - Manual (Page 14)

Special Functions
MULTI Button
The MULTI Button can be programmed to issue
several commands at the same time.
Example; TV Power/On, VCR Power/ON, and Cable
Box Power/On.
Procedure:
1. Enter proper infrared codes for all devices before
programming. See code section.
2. Point your Remote Control Transmitter away from
all equipment remote sensors, then:
Press and
keep holding
L i ^ © . © !
Press and keep
holding for 3
seconds
Release after 3
seconds
( mul ^
Press
0
NOTE: Waiting more than 30 seconds without pressing
another button will exit the programming mode.
3. Press a maximum of 6 function buttons on the
Remote Control. Each button you press is equal to
one function. If 6 Remote button functions are
entered, all will register in the
button
memory when the sequence is entered. When
finished, press the cmult P' to exit the programming
mode.
NOTE: Buttons which continuously perform a function
as long as pressed (Volume Up/Down, Channel
Up/Down, etc.) cannot be programmed; only those
buttons which perform a function when initially
pressed {Power On/Off, Mute, Direct Channel
Entry, etc.) can be programmed.
The following is a flow chart example of remote
functions that can be programmed into the
button:
PRESS AT THE SAME TIME PRESS
Pressing the cmultp » button will now activate the VCR
Power/On, Cable Box Power/On, and the Receiver
Power/On at the same time.
RECALL Button
Press the RECALL Button to review:
(T) Audio Mode status
CH number or Video Input selected
Channel Caption (Station Identifier)
Clock time
Sleep Timer status
© ®
R-TUNE Button
Pressing the R-TUNE (RAPID TUNE) button toggles to
the previously tuned program.
PROGRAM
CURRENTLY VIEWED
PROGRAM
PREVIOUSLY VIEWED
Press Button
Press Button Again
-
14
-