Programming the home theater remote – Panasonic CT-3696VY-1 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Programming the Home Theater Remote
The remote control can be set to control other manufacturers components, by utilizing the
MODE SELECTION
BUTTONS
for
CABLE, DSS, VCR, RCVR
(a
Receiver
or
Amplifier), CD, LD,
and
AUX
(for
Cassette Players,
Second VCR
or a
DVD).
Code Known
Code Unknown
Use the following procedure for setting up the
remote control using the numerical buttons when
the component’s remote code is known.
[B Determine the brand of the component.
[2] Identify the code(s) associated with the
brand from the infrared code index (see
[
following pages). Record all possible
codes.
[3] Confirm that the component is plugged in
and operating properly, then turn it OFF.
® Press and hold the fezj] button, then
the p^R) button so that both are
pressed
at
the
same
time
for
BTtgggrS'g^OTVdg. Then let go of the
buttons.
^
Press the appropriate MODE button
for the component.
[6] Enter the 3-digit-code, by using the
Remote Control Keypad “0” through
“9” buttons.
Now the remote is set for the entered
code.
[6]
Code From
Index Sheet
Use the following procedure for setting up the
remote
control
when
the
component’s
remote
access code is not known. This procedure uses the
“sequence method”.
D
Confirm that the components is plugged in
and operating properly, then turn it OFF.
TNQ2AE012
[Zl
Press the button to test the remote.
If the correct code is
setup for the
component (in step №]), the component
will turn on.
Note:
Some brands have multiple codes. Repeat
the procedure using another listed code
until the component responds correctly.
button, then
Press and hold the ^
the POWERS button so that both are
pressed
at
the
same
time
for
ianeast~5~seconds.
Then let go of the
buttons.
Press the appropriate Mode button for
the device.
Press the
next code.
button to step over to the
B Press the
po
^
r
> button to test the
remote. If the correct code is sent, the
component will turn on.
S Once the correct code is found, press
the button to store the code.
O Repeat from step H above until the
proper components code is found. It may
take several attempts before the correct
code is found.
Note:
If an incorrect code is entered, or when
the operation is not completed within 30
seconds, the settings will not change.
-
32
-