Sequential switching time, Sequential switching time table 1 – Panasonic WJ-SQ308 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Sequential Switching Time
Table 1
Signal Output Condition
Without VCR
With VCR
Sequential Switching Time
The sequential switcher’s timing can be
adjusted using the Time Control (1) when the
Time Internal/External Selection Switch (2) is
set to the INT position.
The sequential switcher's timing can be
adjusted by the timing pulse from VCR when
the Time Internal/External Selection Switch
(2) is set to the EXT position.
Note:
When the VCR is turned off, the sequence is
stopped.
Normal Sequence mode
Signal can be output sequentially by the
Signal can be output with the sequential tim-
1. Alarm/Spot Output Connec
tor
2. Alarm/Sequential Output
Connector
switching time set with the Time Control (1).
ing by the timing pulse from VTR.
Spot mode
1. Alarm/Spot Output Connec
tor
2. Alarm/Sequential Output
Connector
1. The signal is output with Spot switching.
1. The signal is output with Spot switching.
2. The signal is output sequentially.
2. The signal is output sequentially.
Alarm mode (1 input)
1. Alarm/Spot Output Connec-
1. The alarmed video signal is output from
1. The alarmed video signal is output from
tor
the Alarm Spot Output Connector (11).
(The spot operation is available for 1-ch -
8-ch)
the Alarm Spot Output Connector (11).
(The spot operation is available for 1-ch -
8-ch)
2. Alarm/Sequential Output
2. The alarmed video signal is output from
2. The alarmed video signal is output from
Connector
the Alarm Sequential Output Connector
(10).
the Alarm Sequential Output Connector
(10).
Alarm mode (multiple input)
1. Alarm/Spot Output Connec-
1. The alarmed video signals are output
1, The alarmed video signals are output
tor
sequentially from the Alarm/Spot Output
Connector with the timing set by the Time
Control (1). (The spot or bypass operation
sequentially from the Alarm/Spot Output
Connector with the timing set by the tim
ing pulse from VCR. (The spot or bypass
is available for 1-ch- 8-ch)
operation is available for 1 -ch - 8-ch)
2. Alarm/Sequential Output
2, The alarmed video signals are output
2. The alarmed video signals are output
Connector
sequentially from the Alarm/Seq Output
Connector with the timing set by the Time
Control (1). (The bypass Operation is
available for 1-ch - 8-ch)
sequentially from the Alarm/Seq Output
Connector with the timing pulse from VCR,
(The bypass Operation is avaiiable for 1-
ch - 8-ch)
Note: The switching interval ol VCR and camera should be 0.3 seconds or more.
-
8
-