Panasonic TOUGHBOOK CF-48 - Manual (Page 25)

10 At the confirmation message , press (S.
The computer will reboot, and the operations of reinstal­
lation for the hard disk start automatically. (The opera­
tions take about 15 minutes.)
(KKHDCKHID
When “Insert media 2” is displayed, insert Product Re­
covery CD-ROM 2, or when “Insert media 3” is displayed,
insert Product Recovery CD-ROM 3 into the CD drive
and immediately select [OKJ.
(In the case of Windows NT, only Product Recovery CD-
ROMs 1 and 2 can be used.)
X note >
If [OK] is not immediately selected:
The message “The media does not contain the correct
file” may appear. In such cases, the message “Insert
media 2...” is displayed again when [OK] is selected.
Confirm that Product Recovery CD-ROM 2 has been
inserted by opening the tray of the CD drive, then close
the tray and immediately select [OK].
11 After the reinstallation procedure completes, the follow­
ing message will appear on the display.
All data on the whole HDD has been restored to the factory default.
After removing floppy disk and the Product Recovery CD-ROM,
restart the computer and set up Windows again.
Remove the Product Recovery CD-ROM and FIRST AID
FD, then restart the computer by pressing ( Ctrl ) +
CMD+CgeD.
____________________
Windows2000 install wizard will start after reboot.
Restore process will execute more after Windows2000 install wizard.
Restart the computer after removing floppy disk and CD.
Remove the Product Recovery CD-ROM, then restart the
computer by pressing fctiD + (3iD+CfeD
(w/iiriSimiai-)_________________________________
Windows NT4.0 install wizard will start after reboot.
Restore process will execute more after Windows NT4.0 install wizard.
Restart the computer after removing floppy disk and CD.
Remove the Product Recovery CD-ROM, then restart the
computer by pressing C'ctrD+
OD+CSiD.
12 When the message [Press <F2> to enter SETUP] is dis­
played, press ( F2 ) and then run the Setup Utility.
If the password has been set, enter the Supervisor Pass­
word.
73 Press C F9 ).
At the confirmation message, select [Yes] and press
C Enter ]. (The Setup Utility settings will return to their
default values. Even the security settings with the excep­
tion of the password(s) will return to their default values.)
Change the settings where necessary.
14 Press C F10 ).
At the confirmation message, select [Yes] and press
C Enter ].
15 Perform the setup procedure for Windows by following
the instructions on the screen.
Q" page 11
(WUniMn page 12
25