Panasonic SCAK75 - Manual (Page 14)

LhfBning to CDs
You can set and remove CDs while a CD is playing.
How to set CDs
1. Open the rack panel.
liBBi
Except when setting or removing CDs, keep hands out of the
changer while open. You could injure yourself if somehow entangled
in the internal mechanism.
2. Slide the loader carriage to the slot you want
The loader carriage has a LOCK position (when the lever is
down) and a RELEASE position (when the lever is up). When
you slide the loader carriage to select the slot you want, make
sure it is in the RELEASE position.
You can read the numbers between the prongs as shown below.
C
.0
c
s
H)
§■
8
Slot No. 0 (SINGLE) is reserved for single CD play
(-^ page 17).
3. © Lower the lever on the loader carriage and
set the CD in the groove with the label facing
to the right
@ Raise the lever.
Label side
4. Close the rack panel gently.
You will hear a catching sound when the rack panel closes.
Press on center
piece.
How to remove CDs
1. Open the rack panel.
2. Slide the loader carriage to the slot you want.
Do not slide the loader carriage when the lever is down.
3. Push the end of lever down.
The CD rolls out into the loader carriage.
Remove the CD now.
To prevent damage
Always observe the following points.
• Never load more than one CD in any given slot.
• Do not use 3" (8 cm) CDs fitted with expander rings.
• Do not put anything other than CDs in the changer.
• Do not set a CD in the slot of the CD being played (slot flashes).
• Sometimes the rack panel cannot be opened while a CD is play­
ing. Wait until it can.
• Do not open the CD front panel and press the eject button when
“SEARCH” appears in the display.
• Do not use cleaning CDs or CDs which are badly warped or
cracked.
• Set the system on a flat, level surface.
Do not set it on top of magazines, inclined surfaces, etc.
•Always unload all CDs before moving the system.
•Do not use CDs with poorly attached labels or stickers.
Adhesive protruding from underneath stickers or left over from
peeled off stickers can cause the system to malfunction.
• Do not use irregular shape CDs.