Panasonic SCAK75 - Manual (Page 31)

□
- VOLUME +
B
:|J
»■5
CH SELECT
i“ >
u C n
> 1 ^ 1 77 .
) _ i (_( j j
m
l o o
- CH LEVEL +
■ l ~ r
i_ c n
I I ~ l
—t >-J JJ
by remote control
Press VOLUME (—) or {+) to set the volume
level normally used for enjoying the source.
The following steps are for setting the output level of the front
speakers and the center/surround speakers to the same listen­
ing level.
by remote control only
Press CH SELECT to select the center or
surround speakers.
by remote control only
Press CH LEVEL (—) or (+) to adjust the out­
put level.
Adjust the output level of each speaker from the listening posi­
tion until they are all the same.
Decrease the output level.
-I-: Increase the output level.
Output level can be varied within a range of -12 dB to -i-12 dB
with front speaker output level serving as the zero point.
The test signal is output only by the speaker you are now ad­
justing and does not repeat the sequence until adjustment are
complete.
To stop the test signal
Press TEST.
To turn off the DOLBY PRO LOGIC systems
Press DOLBY PRO LOGIC.
Press once again to turn it on.
Press DOLBY PRO LOGIC to turn on the
DOLBY PRO LOGIC system.
The button lights up.
Press once again to turn it off.
Select and start the desired source.
To turn off the DOLBY PRO LOGIC systems
Press DOLBY PRO LOGIC.
DOLBY PRO LOGIC
I
h I
Ì I
# # » *. ■* ■# * *
* f *■ » * I ■*
S V ^ i t S .» » • : ■ * * * » ■ * ■
. * . * i : - * * • 4 ^ i ■ i - «